Dual Universe Creators

I proudly Present the Wydee-Design warp cell factory! The warp cell factory can produce 188 warp cells a day without any talents and goes up to 240. Put the ores on the input HUb on the control room at the entry of the factory and everything is being produced for you without any action to do. Everything is well designed inside and organized in a very clear industrial layout. We bring to you lean and visual management. Production behavior: - There is enough container storage to handle a complete week production - The consumption for a week is the following: - Bauxite ~48k - Hematite ~24k - Coal ~63k - Quartz ~91k - Malachite ~18k - Limestone ~35k - Natron ~14k - Pyrite ~12k - Petalite 2.6k - Acanthite ~14k The required schematics to make this run for a WEEK are the following: - Pure product schematics P2: ~1170 - Pure product schematics P3: ~ 500 - Product schematics P1: ~1750 - Product schematics P2: ~350 - Product schematics P3: ~ 210 - Warp cell schematics: ~ 1400 All those numbers are the minimum required (with a buffer included) to make the factory running for a week with: - no talents on speed increase for production - talents lvl 5 pure P1 - talents lvl 3/4 pure P2 - talents lvl 3/4 pure P3 - talents lvl 1/4 on basic products (polycarbonate / polycalcite / polysuflide / alloys (Al-Fe, Cu-Ca-Cu-Ag / Glass (basic, advanced, Ag-Li) If your talents are a bit high than this increase the capacity to make a full run for a week by 10%. Those numbers are mentionned on the screens inside the entry hall where the materials must be inserted in front of each Hubs and maintain rules are also mentionned. To deploy the factory the entrance is in front of you when you deploy it. For BP come to see me on Haven @ ::pos{2,27,27.7968,346.8901,40.2505} or contact me on discord JamesWydee (james78650)#9448 Token are not available for now: depending on the demand I will organize myself for make those available when my talents are going to be updated to LVL 5 (in one month would be available). Come to see the factory by VR @ Wydee_ShowRoom

A futuristic looking hovering mining drone with: - 4 mining units - 1 container L with an accessable hub at the ground - an elevator to the top for calibration (must be brought to the ground after placing the mining drone so that it is not stuck in the ground. The elevator is located directly under the antenna m) - core size M, to be able to place more containers around the drone for additional space or decorative reasons

In the process of moving, blueprints are available to Kosmos Exchange. It's Honeycomb...in space! No longer will you need to make element only ships deep in space, put some voxels on it and style that thing up! PvPers, come on, put a skin on that naked hot dog you're shooting with. You can even dress it up as an actual hot dog with the right voxels at your fingertips. Factory is built on my Fidget station technology and features T1-T3 honeycombing capabilities. Easy to use LUA control for the honeycomb machines (html needs to be enabled for T3 due to a technical issue with Aerogics honeycomb script so using SilverZero's older script that still works like a champ). Come see it in VR at "Czar in Space Showroom" either fly outside or head to the small unmarked door on the end with the landing pad sets. Located in person here ::pos{0,0,-41989.3752,202219.7557,33651.8498}

PYRAMID SHIP PARTS FACTORY: A SHIP BUILDER'S DREAM! MAKES EVERY SHIP ELEMENT EXCEPT ENGINES ENGINE FACTORY COMING SOON ALSO MAKES PROGRAMMING BOARDS AND DATA BANKS HAS EXTRA ASSEMBLY LINES TO ADD YOUR OWN EXTRA PARTS THIS FACTORY IS A BEAST! DONT MISS OUT! OUR SCREEN FACTORY IS A GREAT COMPLIMENT TO THIS FACTORY LIKE ALL OUR FACTORIES; COMES WITH: INGAME AND DISCORD SUPPORT. ALL MACHINES ARE LABELED TO MAKE SCHEMATIC PLACEMENT A BREEZE. ALL CONTAINERS ARE HUBBED TO MAKE ADDING STORAGE CAPACITY A BREEZE TOO! ENJOY! CHECK OUT OUR BIO FOR MORE PYRAMID CO INFO

The Dune Dwellers of Haven have perfected harvesting the planets resources with their specialized Mining Silo's. Designed with a Basic Container M & 4x Mining Unit L's, this resource facility can store up to 7 days worth of resources for a single weekly haul. Over 80kL of ore storage! Calibration can be done via the platform deck in RPG style, or for those seeking efficiency through the bottom where the ore will calibrated ore will spawn. Looking up from the bottom you can see the machinery in action as it chews up the ore being extracted from the dunes below. (Tokens will not be made available) Featured by: - Landmark Explorer Twitch Channel

ETA Fuel Refiner is great for solo or small groups of players. Makes all Fuels. BP requires 3L containers 4M containers 2 S containers 4 Hubs 3 Basic chemical 2 Basic Recycler 3 Square light s 1 Vertical light s Location: ::pos{0,2,15.0650,96.8392,0.0000}

Available in two different styles! Need 7680kl of storage in a box a lil larger than a XS core? This is the box for you! 10 XXL containers in the space that would normally be only 4 containers. Perfect for docking to ships, or base set ups. Perfect for any place, where you need to save space. Purchase 1 BP for 5m, or 3 BPs for 10m. --- Discord --- https://discord.gg/KcafbTSwMp --- Buy Locations --- Locura Shipyard @ (::pos{0,2,29.8840,107.7111,9.7555}) --- VR Locations -- View Units: Locura Ship Museum -- Other VR Locations -- Locura Exchange

THE MONOLITH During ground works for our base, we have unearthened a strange artifact of possible alien orign. None of our instruments was able to penetrate this object or to get any data. You can see it first-hand, when VRing to "Tropico". We decided, to make this artifact available to you all, in hope that your technologies can retrieve the deep secrets it bears within. INSTRUCTIONS The dispenseris on location, as part of the excavation site. There are two blueprints - one for the monolith (MON) and one for the excavation site (SIT). At your own location, find an area that is as flat as possible. If there are small elevations, the center of SIT should be at the lowest area. Sink it into the ground, but make sure that somewhere a little bit of the upper wall remains above ground. Look how it is done at our location. After it has been placed, use your digging tool (2) to create a small tunnel downwards, along a wall. Each wall contains 5 sections, one above each other. Stop the tunnel when you have reached the lowest of those 5 sections. Now use tool 5 to create a flat floor inside the four walls. Then remove the soil that is still above your head inside the walls, avoid removing soil outside the walls. Use now the Smooth Voxel tool along the walls to raise the floor unevenly along the wals, especially at the four corners. Do some landscaping to make the floor a bit uneven. Important: you must not see any of the steel honeycombs. Do not yet create the small "hill" in the center. Now place the MON slightly above the floor. Now create the small "hill" below it to hide the core. Finally, do some additional work on the surrounding area, to make it looking perfect. When you're done, post "My god, it's full of stars" in the general ingame chat! :-D HURRY, THERE ARE ONLY 10 BLUEPRINTS!

PYRAMID HONEYCOMB FACTORY: Need a lot of voxels? look no further. This factory comes equipped with 10 honeycombers set to make; Wood, Brick, Concrete, Carbon fiber, Steel, Plastic, 2 for iron and 2 for aluminum. We customize these for people a lot! Need stainless steel no problem! need calcium voxels no problem. Don't be afraid to ask for some modifications. Your personalized BPs will be put in a personalized dispenser for you upon completion. Can be customized for any T1 and T2 honeycombs for just 2 mil extra. Can also be customized for T3-T5. Just contact us for pricing! We work with you to make sure you're getting exactly what you want! ***************************************************** **********************ATTENTION******************** MORE MODELS AVAILABLE!! We now have a model that will run 10 honeycombers all the same product. Will work for all basic T1 honeycombs. Also have a 10x model for just steel one for brick and one for plastic too!! Will make voxels faster than you can place them! Cook 10 different flavors at once! READ OUR BIO FOR MORE INFO

Ikara Industries presents the "Ikara Factory M1" - Elemetns and Script Rework. Produce and rest, then the Ikara Factory M1 is for you. The M core includes - 5 floors for space up to XL machines - 1 basement with the possibility to integrate up to 84 L containers - 1 factory control center with 4 L screen - Door script (RestrictedAccessDoor) provided by Davemane42 - Light Control (ScreenLightControl) script provided by DU_ASTco - Screen Script to set Text to the Lounge and Entry Screen - Large window front - 2 lounges with benches and snack machines. When the production takes longer. - 15 L screens with the Entropy Effect to chill on the top. What else you should know: - Building has DRM - All screens must be turned on once manually. VR: Ikara Industries or Ikara Industries Exchange Where to buy ? Ikara Industries or Ikara Industries Exchange (on the Alioth Exchange Yellow Hall) Questions? - Message @Ikara2184#2629 on discord.

Originally designed in Alpha 1, this stalwart Logistics Centre is a great benefit to most serious solo players, and small to medium Organisations. Boasting a whopping 201 Large Containers, managed over 68 Hubs to provide 576kl each at Basic level, this Logistics Centre can really help ensure you keep organised and well stocked! Featuring two Storage zones (one above, one below ground), two large offices for Lua projects, entertaining guests or providing a dispenser store front, with two smaller offices for personal use, a loading bay for small haulers and 2 landing pads on the roof, capable of handling smaller M core ships. Please note: Decorative elements are used only for advertisement / suggestion. Location & VR: Makashima Industries Shop ::pos{0,26,79.6509,-87.6931,99.0025}

50% off blueprint price at the moment on dispenser This large landing area covers the floor space of a Large static core its a must visit you can visit in vr search: loaded industries showroom and head across the runway to check it out, heres also a quick video link https://www.youtube.com/watch?v=SrIdpuqcb9s

Welcome to Digital engeneering Are you someone that like to do LUA, but do not like to build? Or you just need a nice building to work in with your LUA scrips, and then show a new script for the consumer? And even sell the scrips on the main floor. Then is something for you.

McBain Rocket Shop Showroom Floor with Attached Factory Version 1.0 This is a multi-large core build, in total there are 4 large cores, one for each pedestal, one for the factory and one for the hangar. I wanted a hangar attached to my factory, some place I can work and build XS and S ships with good lighting and manufacture tokens all in the same structure. Near future I will have attached landing pads and voxel library storage area. The showroom area is just about the length and width of a large core large enough to showcase or store several small and extra small ships. The factory is five open floors of space with a floating control center. Currently have installed enough machines to make all parts basic thru advanced and have only used a quarter of available space. There are 2 landing pads and an observation deck with elevators to move about quickly. Pedestals available if needed. I am located on Haven just south of Market 7 ::pos{0,27,54.8276,6.0061,12.2331} VR <= Mcbain Rocket Shop => come by for a walk around.

PYRAMID CANNON AMMO FACTORY XSSMLTK: Need cannon ammo? Need a lot of it? This factory makes 8 different types of cannon ammo! XS, S, M, L kinetic and thermic makes 1000's of rounds per day! low build cost (approx. 6mil) we sell everything needed to build our factories on site. Happy hunting! read our bio for more info:)